In order to insure your safety and the proper use of the PEACOCK handwarmers, carefully read all the instructions below, Do not refill the unit until it has fully cooled down:
Take off the perforated top cover and remove the burner by holding it lengthwise. Do not touch or pull the burner element (shown in Fig.1 in red).
Dirt from fingers will damage it. Also, do
not touch if warmer or burner is too hot.
Insert the bottom of the filling cup into the mouth of the fuel tank and fill the filling cup until it reaches
the line. Click here to see the capacity of each
type of warmers.
Rotate the filling cup 90º in either direction to allow
the fuel to flow into the warmer.
When all the fuel has been absorbed, remove the
filling cup. Hold the warmer upside down and press
lightly 2 ¯ 3 times with your fingertips to discharge
the excess fuel into the cup. Replace the burner.
To light the unit using a match only, hold a
flame to the burner element for between 3 ¯ 5 seconds.
Warning DO NOT light the warmer upside down when lighting, this will cause damage to the burner element.
Replace the perforated top cover.
Put the warmer in its velveteen bag and close it tightly using the drawstring and stopper before using the warmer.
